Tape drives remain the leading technology used by organizations for backup and archiving. However, the plethora of tape drives on the market can make choosing the appropriate tape drive a confusing task. How do you select a tape drive that satisfies your needs without blowing the budget? The following are just some of the main factors to consider.
Select a tape drive that has sufficient capacity to store your backups. Tape drives are able to compress data so that more data may fit on the tape, which is why manufacturers specify both a native capacity and a compressed capacity, usually with a compression ratio at 2:1. However, highly-compressed files such as those in video and sound formats are hardly compressible at all. For this reason, do not heed the specified compressed capacity when choosing a tape drive.
A good way to determine the size of the backup job after compression is to study logs of past backups. If these are unavailable, it is safe to assume that the data can be compressed at a ratio of 1.4:1, unless the hard drive contains an usually large number of highly-compressed files.
2. Transfer rate.
The transfer rate of the tape drive is becomes important when there is limited “window of opportunity” in which tape backup jobs may run. It is often desirable for backups to take place during the night when network use is at its lowest. Select a tape drive that is capable of completing a tape backup job within your window of opportunity. For instance, to back up 400GB per night, you will require a transfer rate of about 30GB/hour.
A little known fact about tape drives is that data must be supplied to them at a sufficient rate in order to keep them streaming, or else the tape suffers from start-stop motion. This motion severely degrades the life of the drive and tapes and the reliability of backups.
There are two usual reasons why tape drives are not be supplied with data at a sufficient rate. Firstly, the rate at which data is read from the hard disk of the server is insufficient. This rate is dependent on the sizes and locations of the files on disk and is generally unpredictable, but can be determined by the use of specialised software.
Secondly, if data is being transferred over a network of computers to a backup server, the network may be incapable of supplying data at a sufficient rate. The maximum throughput of a network is predictable and easy to measure, based on previous network performance.
Consider a network using 10BaseT Ethernet. This transfer rate through this type of network cannot exceed 10MB/s, so it is immediately apparent that a tape drive requiring 20MB/s is inappropriate.
3. Reliability and duty cycle.
A simple way to gauge the reliability of a tape drive is to find out the Mean Time Between Failure (MTBF) as specified by the manufacturer. You should note, however, that the MTBF is usually specified at a certain duty cycle. For example, consider a Travan tape drive with a MTBF of 370,000 hours at 20% duty cycle. The drive will only have an average of 370,000 hours between failures if it is run less than 20% of the time (about 4.8 hours per day), and running the tape drive for any longer will significantly reduce the reliability of the drive.
There is no point purchasing the highest-range tape drive if it’s simply too expensive. Consider how much value-for-money the tape drive will give you. Are you willing to pay more for extra performance? Or do you need to sacrifice some performance to save on costs?
If you choose wisely, you should end up with a tape drive that fulfils your organization’s needs, without blowing the budget.
This article was brought to you by BackupAssist – tape backup software